Search results for "Bulk temperature"
showing 3 items of 3 documents
Modeling of ITER TF cooling system through 2D thermal analyses and enthalpy balance
2017
Abstract The winding pack of the ITER Toroidal Field (TF) coils is composed of 134 turns of Nb3Sn Cable in Conduit Conductor (CICCs) wound in 7 double pancakes and cooled by supercritical helium (He) at cryogenic temperature. The cooling of the Stainless Steel (SS) case supporting the winding pack is guaranteed by He circulation in 74 parallel channels. A 2D approach to compute the temperature distribution in the ITER TF winding pack is here proposed. The TF is divided in 32 poloidal segments, for each segment the corresponding 2D model is built and a thermal analysis is performed applying the corresponding nuclear heating computed with MCNP code considering the latest design updates, such …
<title>Two-dimensional and dynamic (2DD) method of visualization of the flow characteristics in a convection boundary layer using infrared ther…
2000
The paper presents the 2D and dynamic (2DD) method of using infrared (IR) thermography for the visualization of the cooling efficiency of a heated wall, as this method was applied in an experimental investigation. The 2DD method allows the outer surface temperature measured by the IR thermography device to be worked out relative to the bulk coolant-fluid temperature. In this way the 2DD method makes visible the qualitative and quantitative flow characteristics within the thin contact layers at the inner surface of the wall. This flow characteristics, and more specifically the pattern of stream lines (for the detection of dead zones) and the distribution of the temperature differences betwee…
ESTIMATION OF INJECTION PRESSURE DURING MOLD FILLING.
1982
Dimensionless diagrams for estimating the bulk temperature of the flow front and injection pressure in the limit of small viscous generation are obtained. Also, a criterion for neglecting viscous generation is identified, The diagrams, based on the Lord and Williams model, refer to rectangular geometry and amorphous materials. A satisfactory comparison is obtained with literature data taken on polystyrene. A reasonable estimate of polyethylene injection pressure was obtained by roughly accounting for latent heat of crystallization through modified thermal diffusivity.